Y BEARING UNITS

UYS 212 2S

Y-Bearing Plummer Block Units With Grey Cast Iron Housing "S"

3D view

Technical Specification
d	Bore diameter	60	mm
L	Overall length	241	mm
A	Housing contact surface width	65	mm
A1	Width of the top of the housing	47	mm
H	Housing height	136.8	mm
H1	Distance from the contact surface to the bearing axis	69.8	mm
H2	Housing foot thickness	26.5	mm
Jmin	Min. distance between the holes	179	mm
Jmax	Max. distance between the holes	198	mm
N	Height of attachment slot	20	mm
N1	Length attachment end	29.5	mm
s1	Distance from locking device side face to raceway centre	40.3	mm
kg	Mass	4.19	kg
Cdyn	Dynamic load rating	52.7	kN
Co	Static load rating	36	kN
Pu	Fatigue load limit	1.53	kN

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing