Y BEARINGS

UK 212 2S+H 212

Y-Ball Bearings With Tapered Bore

3D view

Technical Specification
d	Bore diameter	60	mm
D	Outside diameter	110	mm
B	Width inner ring	22	mm
C	Width outer ring	22	mm
d1	Outer diameter inner ring	75.5	mm
E	Distance from raceway centre to the hole for lubrication	7.7	mm
d2	Bore diameter-adapter sleeve	55	mm
D1	Hole diameter	95	mm
L	Width adapter sleeve	62	mm
W	KM nut outside diameter	80	mm
Y	KM nut width	13	mm
Cdyn	Dynamic load rating	52	kN
Co	Static load rating	36	kN
Pu	Fatigue load limit	1.06	kN
kg	Mass	0.75	kg

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing