SR EN RU

Y BEARING UNITS

UEP 205 2S

Y-Bearing Flanged Units With Oval Pressed Steel Housing "P"

3D view

Technical Specification
dBore diameter25mm
DaCentering diameter60mm
LOverall width71mm
ADistance from the housing flange to the front of the inner ring of the bearing21.5mm
A1Housing flange thickness2mm
A2Height of the housing9mm
HHousing height95mm
JDistance between the holes76mm
NSqare hole dimension8.7mm
FrRadial load3.6kN
FaAxial load1.8kN
kgMass0.26kg
CdynDynamic load rating14kN
CoStatic load rating7.8kN
PuFatigue load limit0.335kN

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing

UEP 205 2S

×

UEP 205 2S

×

Sealing Type:

Single seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing.

UEP 205 2S

×