Y BEARING UNITS

LET 207 2F

Y-Bearing Take - Up Units With Grey Cast Iron Housings "T"

3D view

Technical Specification
d	Bore diameter	35	mm
D1	Hole diameter	22	mm
L	Overall length	129	mm
L1	Distance from the contact surface of housing to the bearing axis	78	mm
L2	Length of attachment slot	17	mm
A	Overall width	37	mm
A1	Width of location slot	13.5	mm
A2	Housing flange thickness	30	mm
H	Housing height	103	mm
H1	Distance between bottoms of location slot	89	mm
N	Height of attachment slot	38	mm
N1	Length attachment end	12	mm
s1	Distance from locking device side face to raceway centre	25.5	mm
kg	Mass	1.57	kg
Cdyn	Dynamic load rating	25.5	kN
Co	Static load rating	15.3	kN
Pu	Fatigue load limit	0.655	kN

Tehnical Drawing

Sealing

F SEAL / F SEAL (2F)

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal; then the sealing S type, with the labyrinth between the sheet part and the rubber lip that conducts the contact sealing. The friction and speeds are the same as with S but has much better protection against rough impurity particles. It is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides the contact sealing that prevents the penetration of the finer impurities, water, moisture, steam etc. Suitable for heavier conditions due to better protection against foreign matters. It is used with the Y bearings (standard).

Sealing Drawing