Y BEARING UNITS

UYT 206 2S

Y-Bearing Take - Up Units With Grey Cast Iron Housings "T"

3D view

Technical Specification
d	Bore diameter	30	mm
D1	Hole diameter	22	mm
L	Overall length	114	mm
L1	Distance from the contact surface of housing to the bearing axis	70	mm
L2	Length of attachment slot	16	mm
A	Overall width	37	mm
A1	Width of location slot	13.5	mm
A2	Housing flange thickness	28	mm
H	Housing height	104	mm
H1	Distance between bottoms of location slot	89	mm
N	Height of attachment slot	37	mm
N1	Length attachment end	10	mm
s1	Distance from locking device side face to raceway centre	26.7	mm
kg	Mass	1.27	kg
Cdyn	Dynamic load rating	19.5	kN
Co	Static load rating	11.2	kN
Pu	Fatigue load limit	0.475	kN

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing