Y BEARING UNITS

LET 205 2F

Y-Bearing Take - Up Units With Grey Cast Iron Housings "T"

3D view

Technical Specification
d	Bore diameter	25	mm
D1	Hole diameter	19	mm
L	Overall length	100	mm
L1	Distance from the contact surface of housing to the bearing axis	64	mm
L2	Length of attachment slot	16	mm
A	Overall width	34	mm
A1	Width of location slot	13.5	mm
A2	Housing flange thickness	25	mm
H	Housing height	91	mm
H1	Distance between bottoms of location slot	76	mm
N	Height of attachment slot	33	mm
N1	Length attachment end	10	mm
s1	Distance from locking device side face to raceway centre	19.8	mm
kg	Mass	0.88	kg
Cdyn	Dynamic load rating	14	kN
Co	Static load rating	7.8	kN
Pu	Fatigue load limit	0.335	kN

Tehnical Drawing

Sealing

F SEAL / F SEAL (2F)

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal; then the sealing S type, with the labyrinth between the sheet part and the rubber lip that conducts the contact sealing. The friction and speeds are the same as with S but has much better protection against rough impurity particles. It is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides the contact sealing that prevents the penetration of the finer impurities, water, moisture, steam etc. Suitable for heavier conditions due to better protection against foreign matters. It is used with the Y bearings (standard).

Sealing Drawing