SR EN RU

Y BEARING UNITS

UEU 204 2S

Y-Bearing Plummer Block Units With Grey Cast Iron Housing "U"

3D view

Technical Specification
dBore diameter20mm
LOverall length 65mm
AHousing contact surface width32mm
A1Width of the top of the housing21mm
HHousing height63.8mm
H1Distance from the contact surface to the bearing axis33.3mm
JPitch circle diameter50.8mm
GThreadM8mm
G1Thread length14mm
s1Distance from locking device side face to raceway centre 18.3mm
kgMass0.52kg
CdynDynamic load rating12.7kN
CoStatic load rating6.55kN
PuFatigue load limit0.28kN

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing

UEU 204 2S

×

UEU 204 2S

×

Sealing Type:

Single seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing.

UEU 204 2S

×