SR EN RU

Y BEARING UNITS

LEV 207 2F

Y-Bearing Plummer Block Units With Grey Cast Iron Housing "V"

3D view

Technical Specification
dBore diameter35mm
LOverall length 110mm
AHousing contact surface width48mm
A1Width of the top of the housing30.5mm
HHousing height95mm
H1Distance from the contact surface to the bearing axis12mm
H2Housing foot thickness47.6mm
JPitch circle diameter80mm
GThreadM15mm
G1Thread length20mm
s1Distance from locking device side face to raceway centre 25.5mm
kgMass1.44kg
CdynDynamic load rating25.5kN
CoStatic load rating15.3kN
PuFatigue load limit0.655kN

Tehnical Drawing

Sealing

F SEAL / F SEAL (2F)

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal; then the sealing S type, with the labyrinth between the sheet part and the rubber lip that conducts the contact sealing. The friction and speeds are the same as with S but has much better protection against rough impurity particles. It is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides the contact sealing that prevents the penetration of the finer impurities, water, moisture, steam etc. Suitable for heavier conditions due to better protection against foreign matters. It is used with the Y bearings (standard).

Sealing Drawing

LEV 207 2F

×

LEV 207 2F

×

Sealing Type:

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal

LEV 207 2F

×