Y BEARING UNITS

LES 220 2F

Y-Bearing Plummer Block Units With Grey Cast Iron Housing "S"

3D view

Technical Specification
d	Bore diameter	100	mm
L	Overall length	380	mm
A	Housing contact surface width	95	mm
A1	Width of the top of the housing	57	mm
H	Housing height	225	mm
H1	Distance from the contact surface to the bearing axis	115	mm
H2	Housing foot thickness	38	mm
Jmin	Min. distance between the holes	286	mm
Jmax	Max. distance between the holes	330	mm
N	Height of attachment slot	26	mm
N1	Length attachment end	48	mm
s1	Distance from locking device side face to raceway centre	63.4	mm
kg	Mass	17.8	kg
Cdyn	Dynamic load rating	124	kN
Co	Static load rating	93	kN
Pu	Fatigue load limit	3.35	kN

Tehnical Drawing

Sealing

F SEAL / F SEAL (2F)

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal; then the sealing S type, with the labyrinth between the sheet part and the rubber lip that conducts the contact sealing. The friction and speeds are the same as with S but has much better protection against rough impurity particles. It is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides the contact sealing that prevents the penetration of the finer impurities, water, moisture, steam etc. Suitable for heavier conditions due to better protection against foreign matters. It is used with the Y bearings (standard).

Sealing Drawing