SR EN RU

Y BEARING UNITS

LES 214 2F

Y-Bearing Plummer Block Units With Grey Cast Iron Housing "S"

3D view

Technical Specification
dBore diameter70mm
LOverall length 266mm
AHousing contact surface width72mm
A1Width of the top of the housing46mm
HHousing height155mm
H1Distance from the contact surface to the bearing axis79.4mm
H2Housing foot thickness27mm
JminMin. distance between the holes205mm
JmaxMax. distance between the holes215mm
NHeight of attachment slot 25mm
N1Length attachment end 30mm
s1Distance from locking device side face to raceway centre 39.7mm
kgMass6.6kg
CdynDynamic load rating62.4kN
CoStatic load rating44kN
PuFatigue load limit1.86kN

Tehnical Drawing

Sealing

F SEAL / F SEAL (2F)

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal; then the sealing S type, with the labyrinth between the sheet part and the rubber lip that conducts the contact sealing. The friction and speeds are the same as with S but has much better protection against rough impurity particles. It is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides the contact sealing that prevents the penetration of the finer impurities, water, moisture, steam etc. Suitable for heavier conditions due to better protection against foreign matters. It is used with the Y bearings (standard).

Sealing Drawing

LES 214 2F

×

LES 214 2F

×

Sealing Type:

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal

LES 214 2F

×