SR EN RU

Y BEARING UNITS

LES 207 2F

Y-Bearing Plummer Block Units With Grey Cast Iron Housing "S"

3D view

Technical Specification
dBore diameter35mm
LOverall length 167mm
AHousing contact surface width46mm
A1Width of the top of the housing28mm
HHousing height92.1mm
H1Distance from the contact surface to the bearing axis47.6mm
H2Housing foot thickness17mm
JminMin. distance between the holes122mm
JmaxMax. distance between the holes136mm
NHeight of attachment slot 17mm
N1Length attachment end 24mm
s1Distance from locking device side face to raceway centre 25.5mm
kgMass1.53kg
CdynDynamic load rating25.5kN
CoStatic load rating15.3kN
PuFatigue load limit0.655kN

Tehnical Drawing

Sealing

F SEAL / F SEAL (2F)

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal; then the sealing S type, with the labyrinth between the sheet part and the rubber lip that conducts the contact sealing. The friction and speeds are the same as with S but has much better protection against rough impurity particles. It is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides the contact sealing that prevents the penetration of the finer impurities, water, moisture, steam etc. Suitable for heavier conditions due to better protection against foreign matters. It is used with the Y bearings (standard).

Sealing Drawing

LES 207 2F

×

LES 207 2F

×

Sealing Type:

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal

LES 207 2F

×