SR EN RU

Y BEARING UNITS

LES 206 2F

Y-Bearing Plummer Block Units With Grey Cast Iron Housing "S"

3D view

Technical Specification
dBore diameter30mm
LOverall length 165mm
AHousing contact surface width42mm
A1Width of the top of the housing27mm
HHousing height81.4mm
H1Distance from the contact surface to the bearing axis42.9mm
H2Housing foot thickness16mm
JminMin. distance between the holes111mm
JmaxMax. distance between the holes125mm
NHeight of attachment slot 17mm
N1Length attachment end 24mm
s1Distance from locking device side face to raceway centre 22.2mm
kgMass1.12kg
CdynDynamic load rating19.5kN
CoStatic load rating11.2kN
PuFatigue load limit0.475kN

Tehnical Drawing

Sealing

F SEAL / F SEAL (2F)

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal; then the sealing S type, with the labyrinth between the sheet part and the rubber lip that conducts the contact sealing. The friction and speeds are the same as with S but has much better protection against rough impurity particles. It is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides the contact sealing that prevents the penetration of the finer impurities, water, moisture, steam etc. Suitable for heavier conditions due to better protection against foreign matters. It is used with the Y bearings (standard).

Sealing Drawing

LES 206 2F

×

LES 206 2F

×

Sealing Type:

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal

LES 206 2F

×