SR EN RU

Y BEARINGS

UY 210 2S.SH

Y-Ball Bearings With Eccentric Locking Collar

3D view

Technical Specification
dBore diameter50mm
DOutside diameter 90mm
BWidth inner ring 30.2mm
C Width outer ring 22mm
sDistance from inner ring side face to raceway centre 11mm
d1Outer diameter inner ring 62.5mm
EDistance from raceway centre to the hole for lubrication 6.4mm
GsSet screw M10x2mm
swHexagonal key size for set screw 5mm
r1,2Inner ring Chamfer dimension1mm
r3,4Outside ring Chamfer dimension1.5mm
B1Width adapter sleeve43.7mm
d2Locking collar outside diameter67.6mm
B2Width locking collar18.3mm
CdynDynamic load rating35.1kN
CoStatic load rating23.2kN
PuFatigue load limit0.98kN
kgMass0.72kg

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing

UY 210 2S.SH

×

UY 210 2S.SH

×

Sealing Type:

Single seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing.

UY 210 2S.SH

×