Y BEARING UNITS

UEV 208 2S

Y-Bearing Plummer Block Units With Grey Cast Iron Housing "V"

3D view

Technical Specification
d	Bore diameter	40	mm
L	Overall length	116	mm
A	Housing contact surface width	54	mm
A1	Width of the top of the housing	31.5	mm
H	Housing height	49.2	mm
H1	Distance from the contact surface to the bearing axis	12	mm
H2	Housing foot thickness	100	mm
J	Pitch circle diameter	84	mm
G	Thread	M14	mm
G1	Thread length	20	mm
s1	Distance from locking device side face to raceway centre	25.3	mm
kg	Mass	0.56	kg
Cdyn	Dynamic load rating	30.7	kN
Co	Static load rating	19	kN
Pu	Fatigue load limit	0.8	kN

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing