SR EN RU

Y BEARINGS

LY 214 2F

Y-Ball Bearings With Eccentric Locking Collar

3D view

Technical Specification
dBore diameter70mm
DOutside diameter 125mm
BWidth inner ring 85.7mm
C Width outer ring 28mm
sDistance from inner ring side face to raceway centre 34.1mm
d1Outer diameter inner ring 87.1mm
EDistance from raceway centre to the hole for lubrication 8.1mm
GsSet screw M10x1mm
swHexagonal key size for set screw 5mm
r1,2Inner ring Chamfer dimension1.5mm
r3,4Outside ring Chamfer dimension2mm
B1Width inner ring with locking collar68.2mm
d2Locking collar outside diameter92.9mm
B2Width locking collar23.8mm
CdynDynamic load rating62.4kN
CoStatic load rating44kN
PuFatigue load limit1.86kN
kgMass2.5kg

Tehnical Drawing

Sealing

F SEAL / F SEAL (2F)

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal; then the sealing S type, with the labyrinth between the sheet part and the rubber lip that conducts the contact sealing. The friction and speeds are the same as with S but has much better protection against rough impurity particles. It is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides the contact sealing that prevents the penetration of the finer impurities, water, moisture, steam etc. Suitable for heavier conditions due to better protection against foreign matters. It is used with the Y bearings (standard).

Sealing Drawing

LY 214 2F

×

LY 214 2F

×

Sealing Type:

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal

LY 214 2F

×