SR EN RU

Y BEARINGS

LY 309 2F.SH

Y-Ball Bearings With Eccentric Locking Collar

3D view

Technical Specification
dBore diameter45mm
DOutside diameter 100mm
BWidth inner ring 42.9mm
C Width outer ring 29mm
sDistance from inner ring side face to raceway centre 19.8mm
d1Outer diameter inner ring 62.1mm
EDistance from raceway centre to the hole for lubrication 7.1mm
GsSet screw M10x2mm
swHexagonal key size for set screw 5mm
r1,2Inner ring Chamfer dimension1.5mm
r3,4Outside ring Chamfer dimension1.5mm
B1Width inner ring with locking collar58.7mm
d2Locking collar outside diameter70mm
B2Width locking collar20.6mm
CdynDynamic load rating52.7kN
CoStatic load rating31.5kN
PuFatigue load limit1.34kN
kgMass1.44kg

Tehnical Drawing

Sealing

F SEAL / F SEAL (2F)

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal; then the sealing S type, with the labyrinth between the sheet part and the rubber lip that conducts the contact sealing. The friction and speeds are the same as with S but has much better protection against rough impurity particles. It is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides the contact sealing that prevents the penetration of the finer impurities, water, moisture, steam etc. Suitable for heavier conditions due to better protection against foreign matters. It is used with the Y bearings (standard).

Sealing Drawing

LY 309 2F.SH

×

LY 309 2F.SH

×

Sealing Type:

Dual sealing, protection cover placed on the inner ring protects against rough impurity particles and makes the labyrinth with the sheet part of the seal

LY 309 2F.SH

×