SR EN RU

UH 211/50 2S.T

Y-Ball Bearings With Integral Adapter Sleeve

Application: Harvester

3D view

Technical Specification
dBore diameter50mm
DOutside diameter 100mm
WKM nut outside diameter75mm
D2MB Washer outside diameter81mm
BWidth inner ring 45mm
B1Width adapter sleeve25mm
C Width outer ring 25mm
LKM nut width11mm
EDistance from raceway centre to the hole for lubrication 7mm
E1Distance from raceway center to the stopping pin 7mm
MThread adapter sleeve50x2mm
PStopping pin diameter3mm
P1Stopping pin higth2mm
kgMass1kg
CdynDynamic load rating43.6kN
CoStatic load rating29kN
PuFatigue load limit1.25kN

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing

UH 211/50 2S.T

×

UH 211/50 2S.T

×

Sealing Type:

Single seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing.

UH 211/50 2S.T

×