AGRO POINT HUBS

UH 205/20 2S.H.T

Y-Ball Bearings With Integral Adapter Sleeve

Application: Harvester

3D view

Technical Specification
d	Bore diameter	20	mm
D	Outside diameter	52	mm
W	KM nut outside diameter	38	mm
D2	MB Washer outside diameter	42.3	mm
B	Width inner ring	18	mm
B1	Width adapter sleeve	29	mm
C	Width outer ring	16	mm
L	KM nut width	7	mm
E1	Distance from raceway center to the stopping pin	4.3	mm
M	Thread adapter sleeve	25x1.5	mm
P	Stopping pin diameter	3	mm
P1	Stopping pin higth	2	mm
kg	Mass	0.2	kg
Cdyn	Dynamic load rating	14	kN
Co	Static load rating	7.8	kN
Pu	Fatigue load limit	0.335	kN

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing